I create a bootable CD with Seatools for DOS, set the controller in the BIOS to IDE mode and boot from it and the CD either hangs silently, or hangs with an “invalid opcode” error.įollowing the instructions here, I create a bootable USB drive with Seatools for DOS.

I installed Seatools for Windows, and it detects all the HDs in my system except the boot drive, which is the one I want to check. I have a Gigabyte P55-USB3 motherboard, and that I have the Intel controller set to RAID mode: I’d like to use Seatools to do a through test of the drive before replacing it, but the problem is that I can't get it to work. I have a Seagate 1TB HD set up as my boot drive, and according to its SMART parameters, it’s starting to fail: the “Reallocated sectors count” is at 458 (and has been increasing for the last months), while “Current pending sectors” and “Uncorrectable sectors” have recently jumped from 0 to 3. Create a file named ‘syslinux.cfg’ on the drive, with this in it (use correct.Copy the SeaToolsDOS223ALL.ISO to the drive.$ cp /usr/lib/syslinux/memdisk /media/SEATOOLS Copy the MEMDISK bootloader from /usr/share/syslinux/memdisk to the drive:.You can do this by reinserting the drive or by using a command like:

Install syslinux on the drive partition:.

$ sudo dd if=/usr/lib/syslinux/mbr.bin of=/dev/sdb Copy “syslinux” master boot record to drive (The code below is assuming your drive is loacated at “sdb”):.Mark the newly created partition as bootable – You can use Gparted to do this.Format the USB drive and Repartition it as FAT.So here is a guide to create a bootable SeaTools USB drive for Ubuntu: You can get a copy of the bootable iso from here: Its an extremely useful tool to have around as hard disks fail all the time and recognizing a failing hard disk can save you a lot of trouble in the long run. SeaTools is a diagnostic tool to check your hard disk for errors and failure.

Seatools bootable